i’m having problems setting fades (in, out, cross) with ardour 7. sorry if this is a dumb question, but i just cannot set the fades. i pull them out as usual at the beginning / end of regions, but then they spring right back. it’s weird and i’m sure that i’m missing something, but i can’t for the life of me figure out what the issue is, though i’ve been using ardour for years – have not experienced this before.
Ardour 7.0.0, Manjaro KDE: I experienced this behaviour. Dragging the fade to increase it, sometimes it would jump back to be shorter than before.
But when testing with Ardour 7.0.105 everything was working as expected, so I didn’t see any reason for filing a bug. Will test again with a newer “nightly”
I have tested on an old project on my secondary PC (Debian 11 stable KDE + Ardour 7.0 official), and the fades work ok. The project was recorded in Ardour 6.9, FYI.
On my new PC (Manjaro KDE) I can’t test it because I’m in the middle of a project and until I finish it I will continue in Ardour 6.9
when you say the fades “work,” did this mean you tried to extend them, say, out to 30 seconds? it’s been reported on the bug tracker that fades longer than seven seconds were often not possible without the fade region springing back to its initial position.
Ah, no. I haven’t tried such long fades. I only tried a few seconds…
Now I don’t have access to my PCs. When I can (tonight or tomorrow) I try long fades.
does anyone have an installer for v. 6.9 linux? i no longer have this on any of my computers. i haven’t been able to solve this problem with the fades springing back with any of the nightly builds. i have 6.9 installed on one of my travel computers (not the main computer i normally work with) and this issue doesn’t occur in 6.9. unfortunately, i don’t have the installer any longer.