When I try to measure latency I get the message “Signal polarity inverted bad wiring.” Not sure what to do to resolve this I am using audio-technica mic into a Behringer MX602A mixer into an M-Audio Delta 2496 sound card. Would appreciate any advice. Thank you.
Latency measurement is typically performed using a cable from the audio device output to the audio device input, not using the full acoustic path of microphone to interface to speaker. The analog path is a trivial part of the total latency so Delta 2496 line out to line in is all you really need to measure.
This topic was automatically closed 91 days after the last reply. New replies are no longer allowed.