Icon QCon Pro G2 workflow

Hello everyone,

1 mixer window to control surface

can i represent the actual mixer view in the control surface (CS)? So when i click a VCA to show just the VCA members or if i click “show send” on a bus to just show the tracks that are routed to the bus this is shown in the mixer window but is there a way to get that on a mackie protocol device like the icon qcon?

2 channel select to control surface

if i select a track/bus in Ardour in the active channel-bank the CS the track in the CS gets selected. So far so good. When i select a track that’s in another bank, than it gets selected (means, when i switch to the bank i see a selected track there) but is it possible that it automatically switches to the bank where the selected track is?