Applying different reverbs in a project

I was wondering about this matter.
I usually apply a general reverb before the Master which leads to all the tracks.
But.
If I want to apply to a certain track another reverb, or a different one, how can I do it?
I though I could apply the minimum reverb I need for all tracks before the Master, then add another one I need for a certain track.
Though that wouldn’t be a “clean” job since it’s a reverb going in another one.

You could remove the reverb on the master bus and create 2 reverb busses for your 2 reverbs and route tracks to the reverb bus you want to use for each track. You could still route all tracks to the master bus directly, and set each reverb to 100% wet and then use the reverb fader to control the amount of reverb you want.